Installation Tips for NLC Preformed Saw Cut Loops

Use these tips when installing an NLC preformed saw cut loop.

Before you begin: Know the dimensions of the loop you are installing before making your cuts. 

  • Outline the loop. Using a construction crayon, trace the approximate size of the loop you will be installing. An exact measurement is not mandatory, but a more accurate outline makes the loop easier to insert.
  • Mark the corner cuts. Use a wooden 45° triangle as a template. Place it on the three corners of the traced outline, leaving out the lead-in corner, and mark the cuts with your crayon. 
  • Mark the lead-in area. At the corner without a 45° cut, mark a lead-in area approximately 1/2 inch wide by 5 inches long. Any excess loop can be folded into this area after installation.
  • Make the saw cuts. Set the saw blade depth to a minimum of 1" deep, avoiding intersecting corner cuts. Extend the cuts approximately 1 to 1 1/2 inches past the loop sides at the designated 45° corner-cut areas to improve installation flexibility.
  • Clean the cuts and insert the loop. Use a vacuum or air compressor to clean out the saw-cut area, then insert the loop and lead-in. Do not use metal objects to push the loop into the cut. To help avoid loop damage, use a tongue depressor. Fold any excess loop into the 5-inch by 1/2-inch lead-in area.
  • Seal the installation. Seal the loop and lead-in with a proper loop sealant and allow time to dry.

 

For a printable reference of these tips: NLC Sawcut Tip Sheet

Technical Support

For additional technical support, contact National Loop Company at (518) 272-5365.